OUTPOST Wireless Callbox Installation Instructions
C
ALLBOX
C
ONTROLS AND
C
ONNECTORS
.................................
Antenna Connector
The antenna radiates radio signals. Before using the
OUTPOST™ Callbox, make sure the antenna is
securely fastened into the 50Ω BNC antenna
connector. If the Outpost is to be used outdoors, see
page 15 for instructions on properly sealing the
antenna connector.
RF Mating Connectors
An internal cable from the antenna connector is
terminated into a phono style connector for connection
to the radio circuit board.
Captive Plastic Case Screws
A captive plastic case screw is located in each corner
of the case front. These 4 screws are used to secure
the case front containing the radio, to the case back
that contains the batteries.
Charge Jumper
The charge jumper can be set to trickle charge re-
chargeable backup batteries.
+12 VDC Input
Two screw terminal style connectors are used for the
“+” and “-“ connection of an external +12 VDC input.
Sensor Input
Two screw terminal style connectors are used for the
“+” and “-“ connection of an external DC level sensor.
Switch Output (Remote Control Output)
Two screw terminal style connectors are used for the
“+” and “-“ connections of a 1A contact switch closure
output.
Speaker Connector
The internal speaker is connected to the radio printed
circuit board with a polarized connector.
On/PTT Connector
The On/PTT switch is connected to the radio printed
circuit board with a polarized connector.
Pre-Drilled Mounting Holes
Mounting holes located in the 4 corners of the case
back are pre-drilled for mounting to a plate, wall or
post. Once mounted, the case front is secured to the
case back through these same threaded holes.
RJ-11 Program Cable Connector
An RJ11 style connector is used to connect the cable
from the PC programmer to the radio.
Program Button
A small, momentary pushbutton is used for field
programming the OUTPOST™ Callbox.
Program Display
A single digit LED display is used during field
programming of the radio.
Battery Holder
The battery holder inside the case back is used for the
installation of 6 D-cell alkaline batteries. Refer to the
diagram below, or the labels beneath the cells, for
correct installation of the batteries.
Battery Mating Connectors
Polarized, 2-pin mating connectors are used to
connect the batteries to the radio circuit board.
+
-
+
-
+12 VDC Input
Sensor Input
+
-
Switch Output
RF Mating Connectors
50
BNC Antenna Connector
FIG-1: Callbox Assembly, Controls and Connectors
Captive Plastic Case
Screws (4 Corners)
Program Button
Program Display
Battery Mating
Connectors
RJ-11 Program Cable Connector
Battery Holder with
D-Cell Batteries In-
stalled
Pre-Drilled Mounting
Holes
4 Corners
Charge Jumper
Speaker Connector
On/PTT Connector
4 Have questions? Call 800-USA-1-USA (800-872-1872) or visit our website at www.ritron.com
(28 paginas)
Manymanuals.com
Manymanuals.de
Manymanuals.fr
Manymanuals.it
Manymanuals.pl
Manymanuals.cz
Manymanuals.es
Manymanuals-pt.com
Comentarios a estos manuales